Alpine INA-N333R Owner's Manual Page 31

  • Download
  • Add to my manuals
  • Print
  • Page
    / 46
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 30
29-EN
MobileHub
TM
Link Operation (optional)
About MobileHub™ Link (Optional)
Connect a separately sold Junction Box and a portable
telephone (available from Nokia) to control the incoming
and outgoing calls of the portable telephone.
About Icon Indicator
Signal strength indicator: Telephone signal
strength is displayed at 4 levels.
Unread mail icon indicator: lights when there is an
unread short message.
Missed call icon indicator: lights when there is a
missed call.
CAUTION
Even with hands-free operation, a driver can be distracted
during telephone operation or receiving a call. For the sake of
safety, drivers are requested to refrain from operating the
telephone while driving.
For the sake of safety, operations other than incoming calls
and Speed-Dial outgoing calls cannot be used.
NOTES
If a portable telephone is connected, its address book,
incoming and outgoing history, short message history are
downloaded to the Junction Box.
Please refer to the instruction manual of the Junction BOX.
Telephone Mode On and Off
1 Press and hold the BAND/TEL. button for at least 2
seconds.
After the Network Operator display is shown for about
2 seconds, the display changes to the Speed Dial
screen.
See relevant pages for each item.
Press and hold the BAND/TEL. button for at least 2
seconds or press the RTN button to cancel the
telephone mode.
BAND/TEL.
RTN
NOTES
When a portable telephone is not connected, NO PHONE
is displayed for at least 2 seconds, then the mode returns to
the original source mode.
When the portable telephone is taken off the Junction BOX
during an incoming or outgoing call, or during a hands-free
call, the call will be treated as an ordinary one by the
portable telephone.
When there is an incoming call while the power of INA-
N333R is OFF, the power of INA-N333R will turn ON
automatically for a hands-free call.
Even if the power of the portable telephone is OFF, when
INA-N333R is set to the telephone mode, the power of the
portable telephone will be turned ON.
Even if the ACC power of the vehicle is turned OFF (even if
the engine is stopped) during a hands-free call, the call is not
disconnected, and an ordinary call by the portable telephone
is possible.
If there is an incoming call during operation (except an
outgoing call or talking), operation mode will end and switch
to the incoming or talking mode.
An outgoing call from a portable telephone is also possible.
However, you cannot perform different operations at the same
time from a portable telephone and INA-N333R as
malfunction can result.
With a Junction BOX connected, outgoing and incoming
history will also be recorded in the portable telephone.
The telephone volume can be adjusted from the INA-N333R .
The volume you set during the call is memorized, and is
automatically applied again on the next call.
While telephoning, defeat is set to ON. When the call has
finished, the unit returns to your previous setting.
In a status other than telephoning, receiving incoming calls or
making a call, press the TITLE button to show the Network
Operator display for 2 seconds.
After a call, instead of going to a talking mode, the unit
displays the message NO NETWORK COVERAGE or
BUSY for about 2 seconds and then disconnects the line.
Within 5 seconds after a call, press the
button, OK
button or MODE knob to redial.
During a call, you can send dial tone signals 1 to 6 using
preset buttons 1 through 6, and dial tone signals 7 to 9, 0,
*
and # by pressing F/SETUP, and then preset buttons 1
through 6.
Pressing the OK button in the navigation mode (when
optional navigation disc NVD-T003 is used) will not allow
selection of message transmissions, item definitions, or items
obtained by moving the Flipper switch.
Page view 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 45 46

Comments to this Manuals

No comments