Alpine CDE-9848RB Owner's Manual download pdf (Page 22)

21-EN

Installation

Slide mounting sleeve from main unit (see

“Removal” on this page). Slide the mounting sleeve

into the dashboard and fix it with the metal

shackles.

When your vehicle has the Bracket, mount the long

hex bolt onto the rear panel of the CDE-9848RB/

CDE-9846R/CDE-9846RM and put the Rubber Cap

on the hex bolt. If your vehicle does not have the

Mounting Support, reinforce the head unit with the

metal mounting strap (not supplied). Connect all

the leads of the CDE-9848RB/CDE-9846R/CDE-

9846RM according to details described in the

CONNECTION section.

•For the screw *, provide a proper screw to the chassis installing

location.

Slide the CDE-9848RB/CDE-9846R/CDE-9846RM

into the dashboard. When the unit is in place, make

sure the locking pins are fully seated in the down

position. This can be done by pressing firmly in on

the unit while pushing the locking pin down with a

small screwdriver. This ensures that the unit is

properly locked and will not accidentally come out

from the dashboard. Install the Detachable Front

Panel.

Removal

1 Remove the detachable front panel.

2 Use a small screwdriver (or similar tool) to push the

locking pins to the “up” position (see above drawing).

As each pin is unlocked, gently pull out on the unit to

make sure it does not re-lock before unlocking the

second pin.

3 Pull the unit out, keeping it unlocked as you do so.

Front frame

Screws (M5 × 8)

(Included)

Mounting Bracket

this unit

Metal Mounting Strap

Screw

Bolt Stud

Hex Nut (M5)

this unit

Accessory List

• Head unit ........................................................................ 1

• Power cable .................................................................... 1

• Mounting sleeve ............................................................. 1

• Carrying case ................................................................. 1

• Rubber Cap .................................................................... 1

• Hex Bolt .......................................................................... 1

• Screw (M5 × 8) ................................................................ 4

• Owner’s Manual ....................................................... 1 set

Note:

The main unit must be mounted within 35 degrees of the horizontal

plane, back to front.

Less than 35°

Lock pin

Dashboard

Rubber Cap

(Included)

Bracket

Mounting sleeve

(Included)

Hex Bolt

(Included)

this unit

∗

1 2 ... 17 18 19 20 21 22 23 24 25 26 27

Comments to this Manuals

No comments

Alpine CDE-9848RB Owner's Manual Page 22

Comments to this Manuals

Related products and manuals for Receiver Alpine CDE-9848RB