23-EN
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10
cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise
suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
1 Antenna Receptacle
2 Audio Interrupt In Lead (Pink/Black)
Connect this lead to the Audio Interface output of a cellular
phone which provides ground shorting when a call is
received.
3 Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
4 Dimmer Lead (Orange) (CDE-9848RB only)
This lead may be connected to the vehicle’s instrument
cluster illumination lead. This will enable the vehicle’s
dimmer control to dim the backlighting of the unit.
5 Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s fuse
box or another unused power source which provides (+) 12V
only when the ignition is turned on or in the accessory
position.
6 Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
7 Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna,
if applicable.
• This lead should be used only for controlling the vehicle's power
antenna. Do not use this lead to turn on an amplifier or a signal
processor, etc.
8 Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle’s
battery.
9 ISO Power Supply Connector
! Fuse Holder (10A)
" Steering Remote Control Interface Connector
To steering remote control interface box.
# Front/Subwoofer* Output RCA Connectors
* When Subwoofer is set to OFF: Output is from front speakers.
When Subwoofer is set to ON: Output is from Subwoofer.
$ Power Supply Connector
% Left Rear (+) Speaker Output Lead (Green)
& Left Rear (–) Speaker Output Lead (Green/Black)
( Left Front (+) Speaker Output Lead (White)
) Left Front (–) Speaker Output Lead (White/Black)
~ Right Front (–) Speaker Output Lead (Grey/Black)
+ Right Front (+) Speaker Output Lead (Grey)
, Right Rear (–) Speaker Output Lead (Violet/Black)
- Right Rear (+) Speaker Output Lead (Violet)
. ISO Connector (Speaker Output)
/ RCA Extension Cable (sold separately)
: ISO/JASO Antenna Adapter (sold separately)
An ISO/JASO antenna adapter may be required, depending
on the vehicle.
; AUX Input RCA Connector (CDE-9848RB only)
This connector allows for input of audio from an external
device (such as a portable player), using a commercially
available RCA cable.
Comments to this Manuals