Alpine NVE-N055PS Owner's Manual download pdf (Page 52)

51-EN

01GB07VPAB222R.fm

ALPINE VPA-B222R 68-02065Z87-A (EN)

Parking Brake Lead Connection

If necessary, use a pinch connector to connect the foot brake lead, parking brake lead, etc.

Connection Diagram of SPST Switch (Sold Separately)

(If the ACC power supply is not available)

• If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately).

• The diagram and the fuse amperage shown above are in the case when VPA-B222R is used individually.

• If the switched power (ignition) lead of the VPA-B222R is connected directly to the positive (+) post of the vehicle’s battery, the VPA-B222R draws

some current (several hundred milliamperes) even when its switch is placed in the OFF position and the battery may be discharged.

Speaker Input Lead Connection

Cut the car audio's speaker leads.

Connect the leads together.

Connect the supplied pinch connector.

Vehicle Cable

Pinch Connector

Monitor Cable

Stopper

Pliers

VPA-B222R

(Red)

(Yellow)

SPST SW (Optional)

FUSE (5A)

(Optional)

FUSE (20A)

(Optional)

Battery

IGNITION

BATTERY

To prevent external noise from entering the audio system.

• Locate the unit and route the leads at least 10 cm away from the car harness.

• Keep the battery power leads as far away from other leads as possible.

• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.

• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various

noise suppressors, contact them for further information.

• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.

01GB00VPAB222R.book Page 51 Monday, January 23, 2006 4:24 AM

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 76 77

No comments

Alpine NVE-N055PS Owner's Manual Page 52