Alpine TDM-7590R Owner's Manual

ENDEFRESITSER R ALPINE ELECTRONICS, INC.Tokyo office: 1-1-8 Nishi Gotanda,Shinagawa-ku,Tokyo 141-8501, JapanTel.: (03) 3494-1101ALPINE ELECTRONICS OF

8-ENRadio3 Press the BAND button to select the desiredfrequency step (50 kHz or 100kHz.) Each timeyou press the BAND button, 50 kHz and 100 kHzappear

FRESDESEIT9-ENRadioAutomatic Memory of StationPresets1 Press the SOURCE button to select the radiomode.2 Press the BAND button repeatedly until thedes

10-ENRDSSetting RDS Reception Mode andReceiving RDS StationsThe RDS (Radio Data System) is a radioinformation system using the 57 kHz subcarrierof reg

FRESDESEIT11-ENRDSReceiving RDS Regional (Local) Stations1 Press and hold the SETUP button for at least 3seconds to activate the setting mode.2 Press

12-ENRDSReceiving Traffic Information WhilePlaying Tape or Radio1 Press the T.INFO button repeatedly until theT.INFO indicator appears in the display.

13-ENCassetteFRESDESEITCassette Player OperationOpening and Closing the Movabledisplay1 Press the c button.The movable display will open.To close the

14-ENCassetteDolby B NR (Noise Reduction)1 After inserting a Dolby B NR encoded tape,press the B NR button.The display shows the "B NR" The

15-ENCassetteFRESDESEITScanning Programmes1 Press the SCAN button to play the first 10seconds of each programme on the tape."SCAN" appears o

16-ENChangerMusic Sensor (M.S.) Skip1 Press the g DN button once to return to thebeginning of the current track.If you wish to return to the beginning

FRESDESEIT17-ENChangerRepeat Play on Single Track orEntire Disc1 Press the F button so that the "F" indicator lightsup.2 Press the REPEAT bu

CHM-S620Alpine CD Changers Give You More!More musical selections, more versatility, more convenience.An Alpine CD Changer adds more musical choices to

18-ENRemoteRemote Control Operation8 g DN ButtonRadio mode: SEEK (DN) ButtonCD changer mode: Press the button to go backto the beginning of the curren

19-ENRemoteBattery ReplacementApplicable battery: Use two “AAA” sized drybatteries or equivalent.1 Opening the battery coverSlide out the battery cove

20-ENInformationCDCD Changer not functioning.• Out of operating temperature range +50˚C (+120˚F)for CD.- Allow the vehicle's interior (or trunk)

21-ENIndication for CD Changer• Protective circuit is activated due to high temperature.- The indicator will disappear when the temperaturereturns to

22-ENInstallation and ConnectionsBefore installing or connecting the unit, pleaseread the following and pages 2 and 3 of thismanual thoroughly for pro

23-EN3Slide the TDM-7590R into the dashboard. Whenthe unit is in place, make sure the locking pins arefully seated in the down position. This can be d

24-EN+,-.~)(/:$&68RchSig GndLchData GroundData BusBatteryShield GroundlgnitionPower Supply Ground%!#"A359742;1Installation and ConnectionsIgn

25-EN1 Antenna ReceptacleConnect to the supplied ISO antenna convertor plug.2 Audio Interrupt In Lead (Pink/Black)Connect this lead to the Audio Inter

26-EN

1-ENENGLISHContentsOperating InstructionsWARNINGWARNING ... 2CAUTION ...

2-ENWARNINGWARNINGThis symbol means important instructions.Failure to heed them can result in seriousinjury or death.DO NOT OPERATE ANY FUNCTION THAT

FRESDESEIT3-ENTape SlackCheck and make sure any slack in the tape is taken upbefore inserting the tape into the unit. A loose tape can getcaught in th

4-ENBasicTurning Power On and Off1 Press the POWER button to turn on the unit.NOTEThe unit can be turned on by pressing any other buttonexcept the c b

FRESDESEIT5-ENBasicDisplay Angle AdjustmentMovable displayThe movable display may be adjusted to 3different angles depending upon user preference.1 Pr

6-ENBasicSetting the Bass ControlYou can change the Bass Frequency emphasisto create your own tonal preference.1 Press the BASS C. button to turn on t

FRESDESEIT7-ENBasicSetting the Treble ControlYou can change the Treble Frequency emphasisto create your own tonal preference.1 Press the TREBLE C. but