Alpine CDE-133BT User Manual

Bluetooth® Software Update Manual for Windows 7 Applicable from 2012 products CDE-13xBT & CDE-W235BT & CDA-137BTi This manual describes the

Close the Bluetooth Device Control menu on the computer. Even though the progress bar is completed after 30 seconds, the update can take up to 5 minut

4. In case of problems... (Fig. 34) (Fig. 33) Double click “Alpine CD Receiver” in the “Devices and Printers” window to open the Bluetooth Device Con

Use the rotary encoder to select “BLUETOOTH” > ENTER > “FW UPDATE” > ENTER (Fig. 38). (Fig. 36) (Fig. 37) (Fig. 38) (Fig. 39) Select

Caution • Do NOT update the Bluetooth firmware while driving. • Do NOT turn off the vehicle or remove power from the Head Unit while the unit is upda

WARNING – Do not update the Bluetooth firmware while driving Head Unit Setup Buttons Illustration The illustration shows the buttons that shall be use

Confirm that the Head Units Bluetooth visible mode is ON. a) Use the rotary encoder to select “VISIBLE M” > ENTER > “VISI M ON” >

From the Windows 7 task bar select “Start” > “Control Panel” > “Devices and Printers” (Fig. 12). Select “Add a Device”

(Fig. 15) (Fig. 16) (Fig. 17) (Fig. 18) The Head Unit will immediately display “PAIRING” followed by “PAIR NO” (Fig. 15). Select Close on the “Add a d

Right click on the device named “Alpine CD Receiver” then select “Properties”(Fig. 20) (Fig. 20) If the window was closed select Start > Control P

2. Updating the Bluetooth Firmware WARNING – Do NOT turn off the vehicle or remove power from the Head Unit while the unit is updating. The update wil

Turn the rotary encoder to select “UPDATE YES” then press ENTER (Fig. 28). Use the rotary encoder to select “BLUETOOTH” > ENTER > “FW UP