Alpine CDE-7860R Owner's Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
15-EN
Subwoofer On and Off
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the g DN or f UP button to select
the SUB-W mode.
3 Press the BAND button to select Subwoofer ON
or OFF.
4 After setting is completed, press the SETUP
button to return to normal mode.
NOTES
Initial mode is "Subwoofer ON."
Set to "Subwoofer OFF" unless the subwoofer is
used.
When the subwoofer is turned on, the subwoofer
output level can be adjusted. For more details, refer
to the Adjusting Volume/Balance/Fader.
Adjusting Source Signal Levels
If the difference in volume level between the CD
player and FM radio is too great, adjust the FM
signal level as follows.
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the g DN or f UP button to select
the FM LV (FM LEVEL) mode.
3 Press the BAND button to select the FM signal
level HI (High) or LO (Low) to make the signal
levels between the FM band and CD player
closer.
4 Press the SETUP button to return to normal
mode.
Changing Audio Level Display
Pattern
1 Press the SETUP button for at least 3 seconds.
2 Press g DN or f UP button to select the
DISP mode.
3 Press BAND button to switch the display pattern.
DISP1:
Lights the Volume indicator.
DISP2:
Lights the mode and value bars to show the
settings in the Bass engine display.
NOTE
The last mode set will remain in effect. The mode and
value bars light and show the Bass engine settings.
DISP OFF:
Turns off the light in Bass engine display.
If you set DISP OFF, the Volume indicator, Audio
Level indicator, and Bass engine displays are not
lit at all times.
4 Press the SETUP button to return to normal
mode.
Example settings:
Bass center frequency: 100 Hz
Bass band width: WIDE1
Bass level: - 6
DISP1 DISP2 DISP OFF
SETUP Operation
BAND
f UP
g DN
SETUP
Volume indicator
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Comments to this Manuals

No comments