Alpine XMA-T200RF Owner's Manual download pdf (Page 21)

19-EN

Installation

Installing the Remote Display Unit

CAUTION:

Do not install the remote display unit near the air-bag of

the front passenger's seat.

• Check the installing location.

• Determine the installing location on the dashboard

(in the center, and flat position).

• Installation using Velcro tape

• In case of installing the remote display unit with the

Velcro

tape attached, cut the tape into two pieces.

1. Without separating the two pieces of Velcro tape,

peel off the paper backing on one side and place on

the back of the remote display unit.

NOTE

Take care not to cover the caution label on the remote display

unit with the tape.

2. Make sure the location selected is free from

moisture or dirt. Peel off the backing paper from the

other side of the Velcro tape on the Remote Display.

3. Place the remote display unit on the installing

location and push the unit to fix securely.

• Installation using flush mount

1. After determining the installing location, install the

flush mount with screws (M2.9 x 20).

2. Insert the remote display unit into the flush mount to

lock securely.

NOTE

To remove the remote display from flush mount, please use thin

plate such as a plastic card to insert to either side of the remote

display carefully. Then the remote display will be released.

Velcro Tape

Flush Mount (included)

Dashboard

Tapping Screws (M2.9 × 20)

(Included)

Flush Mount (Included)

Dashboard

Bracket Mount (Included)

Velcro Tape (Included)

•Installation using flush mount and

bracket mount

1. Make a hole to match the external dimensions of

bracket mount on the installation location of the

dashboard.

2. Insert the remote display unit into the flush mount to

lock securely.

3. Insert the remote display unit and flush mount

combined into the bracket mount and fix them.

4. Insert the remote display unit, flush mount and

bracket mount combined into the hole made at step

1 and fix them.

Installing the FM Modulator Box

The FM Modulator Box can be mounted to any flat

surface using the Velcro tape.

Installing the XM Tuner Box

•Install the unit

1. Using the unit as a template, hold it at its mounting

location and mark the holes to be drilled. Before

drilling, make sure that there are no objects that

could be damaged behind the mounting surface.

2. Drill holes and secure the unit with self-tapping

screws (M4 x 14) supplied.

NOTE

An antenna is required for the proper operation of this

receiver. This antenna must be purchased separately. The

TUA-T020XM receiver can use any antenna that is designed

specifically for the XM receiver. Please follow the installation

instructions supplied with the antenna.

Screws

(M4 × 14)

(Included)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 42 43

Comments to this Manuals

No comments

Alpine XMA-T200RF Owner's Manual Page 21

Comments to this Manuals

Related products and manuals for Car media receivers Alpine XMA-T200RF