Alpine XMA-T200RF Owner's Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 43
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
15-EN
CD
Changer not functioning.
Out of operating temperature range +50˚C (+120˚F) for CD.
- Allow the vehicle's interior (or trunk) temperature to
cool.
CD playback sound is wavering.
Moisture condensation in the CD Module.
- Allow enough time for the condensation to evaporate
(about 1 hour).
Unable to fast forward or backward the CD.
The CD has been damaged.
- Eject the CD and discard it; using a damaged CD in
your unit can cause damage to the mechanism.
CD playback sound skips due to vibration.
Improper mounting of the changer.
- Securely re-mount the changer.
Disc is very dirty.
- Clean the disc.
Disc has scratches.
- Change the disc.
The pick-up lens is dirty.
- Do not use a commercial available lens cleaner disc.
Consult your nearest ALPINE dealer.
CD playback sound skips without vibration.
Dirty or scratched disc.
- Clean the disc; damaged disc should be replaced.
MP3
MP3 is not played back.
There was an error in writing the disc.
- Make sure the format used to write the disc is compatible.
In Case of Difficulty
If you encounter a problem, please turn the power off, then on
again. If the unit is still not functioning normally, please
review the items in the following checklist. This guide will
help you isolate the problem if the unit is at fault. Otherwise,
make sure the rest of your system is properly connected or
consult your authorized Alpine dealer.
Basic
No function or display.
Vehicle's ignition is off.
- If connected following instructions, the unit will not
operate with the vehicle's ignition off.
Blown fuse.
- Check the fuse on the battery lead of the unit; replace
with the proper value if necessary.
Internal micro-computer malfunctioned due to interference
noise etc.
- Press the RESET switch with a ballpoint pen or other
pointed article.
No connection of Battery lead.
- Make sure Battery lead is connected properly.
No connection of ACC Power lead and Ground lead.
- Make sure ACC Power lead and Ground lead are connected
properly.
No Sound.
Volume level too low.
- Turn Volume Control clockwise to desired level.
No tuning of FM frequency.
- Tune to the correct frequency.
No connection of FM modulator and antenna.
- Make sure the FM modulator is connected to the antenna.
When the interference with broadcasting stations occurs.
- Change the oscillator frequency of the FM modulator.
Music skips excessively.
The CD changer has not been mounted securely.
- Follow the installation instructions for proper installation.
Information
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 42 43

Comments to this Manuals

No comments