Alpine CDE-W233R Owner's Manual download pdf (Page 43)

43-EN

About the Rules of Bluetooth Electromagnetic

Radiation Regulation

Declaration of Conformity

 Microphone (Included) (CDE-W235BT only)

 Antenna Receptacle

 Audio Interrupt In Lead (Pink/Black)

Not used for CDE-W235BT.

 Remote Turn-On Lead (Blue/White)

Connect this lead to the remote turn-on lead of your amplifier or

signal processor.

 Switched Power Lead (Ignition) (Red)

Connect this lead to an open terminal on the vehicle’s fuse box or

another unused power source which provides (+) 12V only when the

ignition is turned on or in the accessory position.

 Ground Lead (Black)

Connect this lead to a good chassis ground on the vehicle. Make sure

the connection is made to bare metal and is securely fastened using

the sheet metal screw provided.

 Power Antenna Lead (Blue)

Connect this lead to the +B terminal of your power antenna, if

applicable.

Note

• This lead should be used only for controlling the vehicle’s power

antenna. Do not use this lead to turn on an amplifier or a signal

processor, etc.

 Dimmer Lead (Orange)

This lead may be connected to the vehicle’s instrument cluster

illumination lead. This will enable the vehicle’s dimmer control to dim

the backlighting of the unit.

 Battery Lead (Yellow)

Connect this lead to the positive (+) post of the vehicle’s battery.

 ISO Power Supply Connector

 ISO Connector (Speaker Output)

 Left Rear (+) Speaker Output Lead (Green)

 Left Rear (−) Speaker Output Lead (Green/Black)

 Left Front (+) Speaker Output Lead (White)

 Left Front (−) Speaker Output Lead (White/Black)

 Right Front (−) Speaker Output Lead (Grey/Black)

 Right Front (+) Speaker Output Lead (Grey)

 Right Rear (−) Speaker Output Lead (Violet/Black)

 Right Rear (+) Speaker Output Lead (Violet)

 Fuse Holder (10A)

 Power Supply Connector

 Steering Remote Control Interface Connector

To steering remote control interface box.

You can operate this unit from the vehicle’s control unit when an

Alpine Steering Remote Control Interface Box (optional) is

connected. For details, contact your Alpine dealer.

 MIC Input Connector (CDE-W235BT only)

To M icrophone.

 Front/Subwoofer Output RCA Connectors

RED is down and WHITE is up.

 RCA Extension Cable (sold separately)

 Front AUX Input Terminal

This terminal allows for input of audio from an external device (such

as a portable player), using a commercially-available converter cable.

 USB Terminal

Connect this to a USB Memory or an iPod/iPhone (sold separately).

To prevent external noise from entering the audio system.

• Locate the unit and route the leads at least 10 cm away from the

car harness.

• Keep the battery power leads as far away from other leads as

possible.

• Connect the ground lead securely to a bare metal spot (remove

any paint, dirt or grease if necessary) of the car chassis.

• If you add an optional noise suppressor, connect it as far away

from the unit as possible. Your Alpine dealer carries various

noise suppressors, contact them for further information.

• Your Alpine dealer knows best about noise prevention

measures so consult your dealer for further information.

1 2 ... 38 39 40 41 42 43 44

Comments to this Manuals

No comments

Alpine CDE-W233R Owner's Manual Page 43

Comments to this Manuals

Related products and manuals for Car media receivers Alpine CDE-W233R