Alpine INE-S920E User Manual download pdf (Page 63)

4 Off-road navigation

When first started, Alpine unit calculates routes using the road network of the high quality vector maps

provided with the product.

You can switch the application to off-road mode from the Navigation menu. Tap ,

, and then .

Most of the procedures described for on-road navigation also apply to off-road navigation. However, there

are some that are not available in this navigation mode (for example you cannot open the itinerary as you

have no maneuvers just route points and straight lines between them).

4.1 Selecting the destination of the route

Selecting the start point or a destination (waypoint or final destination) is the same as described at on-

road navigation. The only difference is that route points are linked to form a route with straight lines

regardless of the road network and traffic regulations.

4.2 Navigating in off-road mode

The real difference between the on-road and off-road modes is the navigation itself. When you are on the

Map screen with an off-road route:

• your position and heading is not aligned with the nearest road and

• there is no turn by turn navigation just a recommended direction.

You see a straight line drawn between your current position and the next destination to reach. The Turn

Preview field in the top left corner shows an arrow with your bearing and the distance of the next

destination.

When you reach a waypoint, the straight line will show the direction to the next destination.

When you reach the final destination, navigation ends.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 84 85

No comments

Alpine INE-S920E User Manual Page 63