Alpine CDA-9885R Owner's Manual download pdf (Page 16)

14-EN

01GB05CDA9885.fm

ALPINE CDA-9885 68-08564Z14-A (EN)

Setting the Bass Control

You can change the Bass Frequency emphasis to create your own tonal

preference.

Press A.SEL to select the BASS (Bass Center

Frequency) control mode.

Bass Treble HPF Bass

-1 Press BAND to select the desired bass center

frequency.

80 Hz 100 Hz 200 Hz 60 Hz 80 Hz

Emphasizes the displayed bass frequency ranges.

-2 Press SOURCE/ to select the desired bass

bandwidth.

Changes the boosted bass bandwidth to wide or narrow. A

wider setting will boost a wide range of frequencies above

and below the center frequency. A narrower setting will

boost only frequencies near the center frequency.

-3

Turn the Rotary encoder to select the desired bass

level (–7~+7).

You can emphasize or weaken the bass level.

Press and hold /ESC for at least 2 seconds to

return to normal mode.

• If no operation is performed for 15 seconds, the unit will return to

normal mode automatically.

• The bass level settings will be individually memorized for each

source (FM, AM, CD, etc.) until the setting is changed. The bass

frequency and bass bandwidth settings adjusted for one source are

effective for all other sources (FM, AM, CD, etc.).

• Depending on the connected devices, some functions and display

indications do not work. However, Bass Level is still adjustable if an

audio processor with the Bass function is connected.

• The function is inoperable when DEFEAT is set to ON.

* The adjustment can also be made by pressing Rotary encoder

(AUDIO). Refer to “Adjusting Bass/Treble/Balance (Between Left

and Right)/Fader (Between Front and Rear)/Defeat” (page 13).

Setting the Treble Control

You can change the Treble Frequency emphasis to create your own tonal

preference.

Press A.SEL to select the TREBLE (Treble Center

Frequency) control mode.

Bass Treble HPF Bass

-1 Press BAND to select the desired treble center

frequency.

10 kHz 12.5 kHz 15 kHz 17.5 kHz 10 kHz

Emphasizes the displayed treble frequency ranges.

-2

Turn the Rotary encoder to select the desired

treble level (–7~+7).

You can emphasize or weaken the treble level.

Press and hold /ESC for at least 2 seconds to

return to normal mode.

• If no operation is performed for 15 seconds, the unit will return to

normal mode automatically.

• The treble level settings will be individually memorized for each

source (FM, AM, CD, etc.) until the setting is changed. The Treble

frequency settings adjusted for one source are effective for all other

sources (FM, AM, CD, etc.).

• Depending on the connected devices, some functions and display

indications do not work. However, Treble Level is still adjustable if

an audio processor with the Treble function is connected.

• The function is inoperable when DEFEAT is set to ON.

* The adjustment can also be made by pressing Rotary encoder

(AUDIO). Refer to “Adjusting Bass/Treble/Balance (Between Left

and Right)/Fader (Between Front and Rear)/Defeat” (page 13).

Setting the Bass Center Frequency

Setting the Bass Bandwidth

Setting the Bass Level

Q1 Q2 Q3 Q4

Setting the Treble Center Frequency

Setting the Treble Level

01GB00CDA9885.book Page 14 Friday, November 17, 2006 7:31 PM

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 117 118

Comments to this Manuals

No comments

Alpine CDA-9885R Owner's Manual Page 16

Comments to this Manuals

Related products and manuals for Receiver Alpine CDA-9885R