Alpine CDA-9883R Owner's Manual download pdf (Page 32)

31-EN

01GB06CDA-9883R.fm

ALPINE CDA-9883R 68-08564Z11-A (EN)

Installation

•

The main unit must be mounted within 35 degrees of the horizontal

plane, back to front.

Removal

1. Remove the detachable front panel.

2. Use a small screwdriver (or similar tool) to push the

locking pins to the “up” position (see above drawing).

As each pin is unlocked, gently pull out on the unit to

make sure it does not re-lock before unlocking the

second pin.

3. Pull the unit out, keeping it unlocked as you do so.

Caution

When you install this unit in your car, do not remove the detachable

front panel.

If the detachable front panel is removed during installation, you

might press too hard and warp the metal plate that holds it in

place.

* If the installed mounting sleeve is loose in the dashboard, the

pressure plates may be bent slightly to remedy the problem.

Remove the mounting sleeve from the main unit

(see “Removal” on page 31). Slide the mounting

sleeve into the dashboard and fix it with the metal

shackles.

Detachable

Front Panel

Less than 35°

This unit

Bracket

Pressure Plates

Rubber Cap

(Included)

Hex Bolt

(Included)

Mounting Sleeve

(Included)

Dashboard

∗

Metal Mounting Strap

Screw

Bolt Stud

This unit

Hex Nut (M5)

When your vehicle has the Bracket, mount the long

hex bolt onto the rear panel of the CDA-9883R and

put the Rubber Cap on the hex bolt. If your vehicle

does not have the Mounting Support, reinforce the

head unit with the metal mounting strap (not

supplied). Connect all the leads of the CDA-9883R

according to details described in the

CONNECTIONS section.

• For the screw *, provide a proper screw to the chassis installing

location.

Slide the CDA-9883R into the dashboard. When the

unit is in place, make sure the locking pins are fully

seated in the down position. This can be done by

pressing firmly in on the unit while pushing the

locking pin down with a small screwdriver. This

ensures that the unit is properly locked and will not

accidentally come out from the dashboard.

Lock pin

Front Frame

Screws (M5 × 8)

(Included)

This unit

Mounting Bracket

01GB00CDA-9883R.book Page 31 Friday, November 17, 2006 8:25 PM

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 41 42

Comments to this Manuals

No comments

Alpine CDA-9883R Owner's Manual Page 32

Comments to this Manuals

Related products and manuals for Receiver Alpine CDA-9883R