Alpine IVE-W554ABT Owner's Manual Page 81

  • Download
  • Add to my manuals
  • Print
  • Page
    / 92
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 80
81-EN
01GB06IVE-W554ABT.fm
ALPINE IVE-W554ABT/IVE-W554EBT 68-25285Z79-A (EN)
Installation
Caution concerning the installation location
1
Angle of installation
Install at an angle between horizontal and 30°. Note
that installing at an angle outside of this range will
result in a loss of performance and possibly
damage.
2
Mounting the Microphone.
For safe use, make sure of the following:
location is stable and firm.
driver’s view and operations are not obstructed.
microphone is located where the driver’s voice can be easily
picked up (on the sun visor, etc.).
When you speak into the microphone, you should not have
to change your driving posture. This may cause a
distraction, taking your attention away from safely driving
your vehicle. Carefully consider direction and distance while
mounting the microphone. Confirm that the driver’s voice
can be easily picked up at the selected location.
3
Remove the mounting sleeve from the main unit (see
“Removal” on page 82).
Slide the unit into the mounting sleeve and secure it.
*
1
If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
*
2
The supplied face plate may be mounted.
4
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the IVE-W554ABT/IVE-
W554EBT and put the Rubber Cap on the hex bolt. If
your vehicle does not have the Mounting Support,
reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (*1) already
attached to the vehicle’s chassis. Connect all the
leads of the IVE-W554ABT/IVE-W554EBT according
to details described in the CONNECTION section.
For the screw marked “*2,” use an appropriate screw for the chosen
mounting location.
Caution
Do not block the unit’s fan or heat sink, thus preventing
air circulation. If blocked, heat will accumulate inside
the unit and may cause a fire.
Air ventilation hole
Rear of the Unit
Heat sink
<example>
0 -30°
Cable clamp
(Sold separately)
Microphone
Mounting Sleeve
(Included)
Dashboard
Face Plate*
2
(Included)
This unit
Pressure
Plates
*
1
Hex Nut (M5)
Screw
Bolt Stud
This unit
Chassis
Ground Lead
Metal
Mounting
Strap
*
2
*
1
01GB00IVE-W554ABT.book Page 81 Friday, January 24, 2014 5:43 PM
Page view 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 91 92

Comments to this Manuals

No comments