Alpine CDA-9847R Owner's Manual download pdf (Page 16)

15-EN

Sound Setting

Adjusting Bass/Treble/Balance (Between Left

and Right)/Fader (Between Front and Rear)/

Defeat

Press Rotary encoder (MODE/LOUD) repeatedly

to choose the desired mode.

Each press changes the modes as follows:

BASS → TREBLE → SUBW*

→ BALANCE → FADER →

DEFEAT → VOLUME → BASS

Bass Level: –7 ~ +10

Treble Level: –7 ~ +7

Subwoofer : 0 ~ +15

Balance : L15 ~ R15

Fader : R15 ~ F15

Defeat : ON/OFF

Volume : 0 ~ 35

• If the Rotary encoder (MODE/LOUD) is not pressed within 5

seconds after selecting the BASS, TREBLE, BALANCE, FADER,

DEFEAT or SUBWOOFER mode, the unit automatically returns to

normal mode.

When the subwoofer mode is set to OFF, its level cannot be

adjusted.

Turn the Rotary encoder until the desired sound

is obtained in each mode.

By setting Defeat ON, previously adjusted settings of

BASS and TREBLE will return to the factory defaults.

• Depending on the connected devices, some functions and display

indications do not work.

g f

BAND Rotary encoder (MODE/LOUD)

......................................

Setting the Bass Control

You can change the bass frequency emphasis to create your own tonal

preference.

Press CENTER f. to select the Bass (bass centre

frequency) Control mode.

BASS → TREBLE → normal mode → BASS

2-1

Setting the bass centre frequency:

Press g or f to select the desired bass centre

frequency.

60Hz ↔ 80Hz ↔ 100Hz ↔ 120Hz ↔ 60Hz

The displayed bass frequency is emphasized

2-2

Setting the bass band width (Q-Factor):

Press BAND to select the desired bass band

width.

Changes the boosted bass band width to wide or narrow.

A wide setting will boost a wide range of frequencies

above and below the centre frequency. A narrower setting

will boost only frequencies near the centre frequency.

2-3

Setting the bass level:

Turn the Rotary encoder to select the desired

bass level (–7~+10).

You can emphasize or weaken the bass frequency.

• If no operation is performed within 15 seconds, the bass control

setting will be turned off automatically.

• The bass level settings will be individually memorized for each

source (FM, MW (LW), CD, etc.) until the setting is changed. The

bass frequency and bass band width settings adjusted for one

source are effective for all other sources (FM, MW (LW), CD etc.).

• This function is inoperable when DEFEAT is set to ON.

The adjustment can also be made by pressing the Rotary encoder

(MODE/LOUD). Refer to "Adjusting Bass/Treble/Balance

(Between Left and Right)/Fader (Between Front and Rear)/Defeat"

(this page).

→ 1 → 2 → 3 → 4

(Narrow)←→(Wide)

CENTER f.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 34 35

Comments to this Manuals

No comments

Alpine CDA-9847R Owner's Manual Page 16

Comments to this Manuals

Related products and manuals for Car media receivers Alpine CDA-9847R