Alpine 611 User Manual download pdf (Page 24)

Fig. 19a

J. Swing Beam Drill Locations

1. T

ap T-nut into 3/8’’ hole as shown in

(Fig. 19a)

Note:

If using Laminated Swing Beam, make sure t-nut teeth do not fall between seams of 2'' x 6''s.

2. Place a bottom beam clamp over the swing hanger as shown in (Fig. 19a)

Insert the swing hanger into the beam and thread it into the T-nut until it is flush or near flush with the top of the

T-nut. A screwdriver may be used to twist the hanger (Fig. 19a). Orient swing hanger as shown in (Fig 19a).

4. Use (4) 1-1/4'' screws/nails to secure beam clamp.

5. Check hanger to ensure it does not spin.

6. Repeat for all four hangers.

(4) 1-1/4'' screws

Swing Hanger

Use Screwdriver to aid in tightening

Bottom Beam Clamp

-nut

ammer

3/8'' hole

T-nut

or 1-1/2'' nails

1 ... 23 24 25 ... 36

No comments

Alpine 611 User Manual Page 24