Alpine LXi - LP Operations Instructions download pdf (Page 19)

Alpine Supply Company 36 Direct Vent Gas Fireplace

INSTALLATION INSTRUCTIONS

Fig. 31– Door Assembly Installation

Pull hook forward

and up to slot

on door bracket

Fig. 32– Door Locking Assembly

REMOTE CONTROL (Optional)

An Alpine Remote Control Kit (08501) may be installed

on this fireplace. The remote control kit comes with a

hand held transmitter, a receiver, a wall mounting plate,

The remote control is thermostatically controlled so you

can set the fireplace to the desired room temperature, and

have that temperature maintained. The remote control is

battery powered and will require periodic maintenance to

keep the system working properly.

1. Choose a convenient location on the wall to install the

receiver unit. A 22 Cu.In electrical box may be used. Run

wires from the fireplace valve to the desired wall

location. See the millivolt lead table on page 14 of this

manual for maximum wire runs.

2. Connect the wires to the gas valve (see figure 32).

3. Follow the installation instructions included with the

remote control kit.

 







  

 

 

 

Fig.33– Gas Valve Connection

WALL THERMOSTAT (Optional)

A wall thermostat may be installed if desired. Follow the

wire routing instructions on page 12 of this manual.

Alpine offers two types of wall mounted thermostats.

One is a basic heating type thermostat (part # 08260).

The other is a model (part # 08261). See your Alpine

dealer for additional information on the thermostats.

NOTE: If a Wall Thermostat is desired, there is no

need to install a wall junction box. The thermostat

wire will simply need to be routed to the desired

location of the wall thermostat and made accessible

through a small hole in the drywall. Both types of

thermostats are surface mounted on the finished wall.

They should not be installed until painting is

complete.

PILOT

TP TH

TO WALL SWITCH

REMOTE CONTROL

OR THERMOSTAT

Thermopile

6. Ignite the pilot assembly and test fire the burner. The

flame should flow smoothly to all points on the burner.

If the burner does not burn from all ports. Turn the appli-

ance off and contact your Alpine Dealer before using the

appliance.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Alpine LXi - LP Operations Instructions Page 19

Comments to this Manuals

Related products and manuals for Fireplaces Alpine LXi - LP