Alpine IVE-W530 Owner's Manual Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 70
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
28-EN
2
Touch [Rear].
Rear Select display appears.
This function cannot be used when “Setting the Picture/Sound
Output” (page 38) is set to OFF in the System Setup.
If [Main] on the Rear Select screen is touched, the screen changes to
the main source screen.
3
Touch the desired source such as visual (auxiliary
input, built-in DVD, etc.) to select.
To u ch [Off] to cancel the rear entertainment function.
When the AUX1 IN is set to OFF and AUX2 IN is set to iPod Video,
the AUX source is not displayed. Refer to “Setting the AUX Mode”
(page 37).
Some sources such as DTV (TUE-T250DV), etc., can be displayed on
the rear monitor only when they are the same as the main source.
Switching Display Modes
After carrying out the steps 1 to 3 of “To display the DVD mode screen”
explained on page 29, perform the operation described below.
While your vehicle is parked, touch [WIDE] on the visual
source screen.
Each touch changes the display modes as follows:
In Mode 1 (Wide), the monitor displays a normal picture wider to
fit in a wide-screen monitor by evenly stretching out the picture
horizontally.
In Mode 2 (Cinema), the monitor displays a normal picture by
stretching out the picture horizontally and vertically. This mode is
good for displaying a cinema type picture at the 16:9 ratio.
In Mode 3 (Normal), the monitor displays a normal picture at the
center of the screen with a vertical black band at each side.
Switching the Visual Source Only
(Simultaneous Function)
You can watch the video portion of another source while listening to the
current source.
1
Touch [V.Sel].
The VISUAL selection screen appears.
2
Touch desired visual source.
The visual source is switched to the selected one.
1
Touch [V.Sel].
2
Touch [Normal].
The simultaneous function is canceled.
To apply the setting, set to V.Sel in “Setting the VISUAL Button”
(page 32).
The simultaneous function cannot be used when the Audio source is
in the navigation mode.
When Navi is set in “Setting the VISUAL Button” (page 32), only the
navigation screen can be recalled.
When the AUX1 IN is set to OFF and AUX2 IN is set to iPod Video,
the AUX source is not displayed. Refer to “Setting the AUX Mode
(page 37).
Blackout Mode On and Off
When Blackout mode is turned on, the monitor display will turn off to
reduce power consumption.
This additional power enhances the sound quality.
1
Touch [V.Sel].
The VISUAL selection screen is displayed.
2
Touch [Off].
The backlit-display portion goes out.
3
Touch [Off] again to cancel the display backlight.
To apply the setting, set to V.Sel in “Setting the VISUAL Button”
(page 32).
If any button on the unit is pressed or main screen is touched during
Blackout mode, the function will be displayed for 5 seconds. This
confirms the operation as well as allowing for additional functions
before returning to Blackout mode.
Mode 1 Mode 2 Mode 3 Mode 1
(WIDE) (CINEMA) (NORMAL) (WIDE)
Cancelling the Simultaneous Function
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 69 70

Comments to this Manuals

No comments