Alpine SWD-1600 User Manual

ENSWD-1600aClass D Amplifier Active SubwooferPlease follow these instructions for your safety• Introduction:Please read this owners manual thoroughly

EN• Make all connections securely.• Any unused connections should be insulated with electrical insulation tape.Memo• On cars fitted with computers and

EN• CONNECTIONS FOR SPEAKER LEVEL INPUTHead UnitIf your head unit does not have this lead, then please connect to the the ACC lead of the vehicle. The

EN3. CHECK1Secure all loose cables.CAUTION - ARRANGE THE WIRING SO IT IS NOT CRIMPED OR PINCHED BY A SHARP METAL EDGE. Route the cables and wiring awa

EN1. Set the gain to MIN, Phase to NORM, LPF to CENTER before switching on the system.2. Set the Bass/Treble adjustment to zero on the head unit. Set

ENUSE SPECIFIED ACCESSORY PARTS AND INSTALL THEM SECURLEY. Be sure to use only the specified accessory parts. Use of other than designated parts may d

ENCAUTION IN USECaution!When installing, always use the brackets that are supplied.This product is supplied with brackets for safe use and installatio

ENAlways use the extension power lead included (with 12A fuse), and connect directlyto the +ve battery terminal. Only use the extension power cable in

ENTROUBLESHOOTINGIf you have a problem with the product then please check the following before taking for repair.SYMPTOMS REASON SOLUTIONUnit does not

ENPACKING LISTPRODUCT NAMEPRODUCT NAMEQTYQTYConnector 1Power lead extension cable (2.5M) 1Speaker to RCA connector (3M) 2Mounting brackets3Self tappin

EN1 Carefully consider all installation possibilities and locations.2 Decide where to install the subwoofer.Attach the brackets with the supplied mach

ENWARNING - DO NOT DAMAGE PIPE OR WIRING WHEN DRILLING HOLES. When drilling holes in the chassis for installation, take precautions so as not to conta

EN2. CONNECTION1Disconnect the cable from the negative terminal of the car battery.2Connect• CONNECTIONS FOR RCA INPUTHead UnitRCA lead(sold separatel