Alpine CDE-153BT Owner's Manual download pdf (Page 10)

10-EN

Initial System Start-Up

Be sure to press the RESET switch when using the unit for the first time,

after changing the car battery, etc.

Adjusting Volume

Turn the Rotary encoder until the desired sound is

obtained.

Setting Time

Press and hold AUDIOSETUP for at least 2 seconds to

activate the SETUP selection mode.

Turn the Rotary encoder to select GENERAL, and then

press ENTER.

Turn the Rotary encoder to select the CLOCK ADJ mode,

and then press ENTER.

The time indication will blink.

Turn the Rotary encoder to adjust the hours while the

time indication is blinking.

When the hour has been adjusted, press ENTER.

Turn the Rotary encoder to adjust the minutes while the

time indication is blinking.

Press and hold AUDIOSETUP for at least 2 seconds to

return to normal mode.

Notes

• To synchronise the clock to another clock/watch or radio time

announcement, press and hold ENTER for at least 2 seconds after

setting the “hour”. Minutes will reset to “00”. If the display shows over

“30” minutes when you do this, the time will advance one hour.

• Pressing t will return to the previous mode.

• If no operation is performed for 60 seconds, the unit will return to

normal mode automatically.

RESET switch

Controllable with Remote Control

This unit can be controlled with an optional Alpine remote control.

For details, consult your Alpine dealer.

Point the optional remote control transmitter at the remote control

sensor.

Connectable to Remote Control Interface Box

With an optional Alpine Steering Wheel Remote Control Interface

Box (not included), this unit is controllable from the vehicles

steering wheel controls. For details, contact your Alpine dealer.

Remote control sensor

00ALPINE.book Page 10 Friday, November 1, 2013 11:52 AM

1 ... 9 10 11 ... 64

No comments

Alpine CDE-153BT Owner's Manual Page 10