Alpine Navigation Radio Owner's Manual download pdf (Page 14)

Reference

If you encounter a problem, please review the items in the following checklist. This guide will help

you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your system is

properly connected or consult your authorized Alpine dealer.

Cause

Blown fuse

Ambient temperature over

50°C

Moisture condensation

The car position changed

after the ignition was

switched off.

• Movement on a ferry boat

• Rotation of a parking lot

turntable

• Movement by tow truck

Poor satellite configuration

Measurement is 2

dimensional.

The navigation screen is off.

The disc is dirty.

The pickup lens is dirty.

The remote control batteries

are wearing out.

Symptom

No operation

The present car

position cannot

be measured

correctly.

The

measurement

error is too large.

Screen not

displayed

Cannot read disc

is displayed for a

certain operation.

Unstable

operation

In case of difficulty

Solution

Replace with a fuse of the prescribed

rating.

Lower the temperature in the vehicle

below 50°C, for example by running for a

while with the window open or by using

the air conditioner.

Allow enough time for the condensation

to evaporate (about 1 hour).

Drive for a while with GPS signal

reception.

Move to a location where GPS satellite

reception is easy. (See page 7.)

Press the POWER button on the remote

control.

Clean the disc.

Have the pickup lens cleaned

periodically.

Replace the remote control batteries.

(See page 12.)

1 2 ... 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Alpine Navigation Radio Owner's Manual Page 14

Comments to this Manuals

Related products and manuals for Radios Alpine Navigation Radio