Alpine INA-N033R Owner's Manual download pdf (Page 7)

5-EN

Movable display

The movable display may be adjusted to 3 different

angles depending upon user preference.

1 Press the ANGLE 89 button to adjust the angle of the

movable display.

NOTES

• The display will close a half minute after the ignition key is

turned to the OFF position.

• The adjusted angle of the display is stored in memory. There

is no need to re-adjust the angle when the power is turned

back on.

CAUTION

Keep hands (or any other object) away from the display while it

is opening or closing to avoid damage or injury. The back of the

movable display will get very warm under normal operating

conditions. This is not a malfunction. Do not touch.

Adjusting Volume/Balance (Between

Left and Right)/Fader (Between Front

and Rear)

1 Press the MODE (Audio Control) knob repeatedly to

choose the desired mode.

Each press changes the modes as follows:

NOTES

• If the MODE (Audio Control) knob is not rotated within 5

seconds after selecting the BALANCE, or FADER mode, the

unit automatically returns to the VOLUME mode.

• When the subwoofer is ON, respective levels may be adjusted.

2 Rotate the MODE (Audio Control) knob until the

desired sound is obtained in each mode.

NOTE

When the temperature inside the unit rises, the volume may

decrease momentarily. This is not a malfunction.

Display Angle Adjustment

→ BAL. → FAD. → Vol.

Turning Loudness On/Off

Loudness introduces a special low- and high-frequency

emphasis at low listening levels. This compensates for

the ear's decreased sensitivity to bass and treble sound.

1 Press and hold the LOUD button for at least 2 seconds

to activate or deactivate the loudness mode.

The display shows "LOUD" when the loudness mode is

activated.

Defeat

By setting Defeat ON, all previously adjusted in the bass

engine mode and LOUD settings will return to the

factory defaults.

1 Press the DEFEAT button for more than 2 seconds to

turn Defeat on.

To cancel Defeat, press the DEFEAT button again for

more than 2 seconds.

Switching the Phase of the

Subwoofer Output

You can switch the phase of the subwoofer output to

NORMAL 0° or REVERSE 180°. To select the desired

phase.

1 Press the bass engine button to change to the bass

engine mode.

2 Move the Flipper switch up or down to select SUB.W.

Press the OK button or MODE knob to set the SUB.W.

mode.

3 Press the OK button or MODE knob to change to the

SUB.W. PHASE setting display.

4 Move the Flipper switch up or down to select 0°

(NORMAL) or 180° (REVERSE). Press the OK button

or MODE knob to set.

NOTES

• If no button is pressed within 10 seconds, the Phase of the

Subwoofer Output setting will be turned off automatically.

• After 10 seconds from the completion of operation, the system

returns to the normal mode automatically. If the RTN button

is pressed, the display returns to the previous setting

indication.

1 2 3 4 5 6 7 8 9 10 11 12 ... 32 33

Comments to this Manuals

No comments

Alpine INA-N033R Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Navigators Alpine INA-N033R