9-EN
Spacer
Bracket
Display
Spacer
Pan screw (M3 x 5) x 2
Flush mount
Face
late
Self-tapping screw
(M2.6 x 8) x 4
Side bracket
Side bracket
• Mounting with the flush mount
1. Make holes approximately 178 (width) by 50 (height) mm in size in the dashboard, etc.
WARNING: When making holes, be careful not to damage pipes, tanks, electric wires, etc.
Doing so could lead to accidents or fire.
2. After step 2 on page 7, remove the included side bracket.
3. Remove the spacer from the bracket.
4. Mount the spacer on the display using the included screws.
5. Mount the flush mount on the display using the included screws, then mount this on the dash-
board, etc.
Comments to this Manuals