Alpine HCE-100XM - XM Radio Data Receiver Owner's Manual download pdf (Page 84)

Mounting the antenna inside the vehicle.

1. Clean the mounting location.

2. Put on the antenna mounting plate.

3. Mount the antenna.

Notes:

• Mount the antenna on a flat plane of the dash board or

rear tray.

• Some thermal reflection type or thermal absorption

type glass may interrupt high frequency waves. If

reception is poor with the antenna installed inside the

car, try to mount the antenna outside the car.

• Make sure the antenna is not covered (obstructed) by

any metallic surface or object.

6 Routing the antenna cable.

1. Route the cable using the provided cable clamps

to take up the cable’s slack.

2. Use the waterproof pad when running the cable

under the vehicle’s rubber gasket.

3. Attach the cable at several points using the

remaining cable clamps.

Cable clamp

Water

proof pad

7 Mounting the Voice Recognition Microphone

and Speak Button.

Notes:

For safe use, make sure of the following:

• location is stable and firm.

• driver’s view or operations are not obstructed.

• voice recognition microphone is located where the

driver’s voice can be easily picked up (sun visor, etc.).

When you speak into microphone, you should not have

to change your driving posture. This may cause a

distraction, taking your attention away from safely

driving your vehicle. Carefully consider direction and

distance while mounting the microphone. Confirm that

the driver’s voice can be easily picked up at the

selected location.

• speak button is located where the driver can easily

press the button (near the shift lever, etc.).

When pressing the button, you should not have to

change your driving posture. This may cause a

distraction, taking your attention away from driving

your vehicle safely. Mount the button so that the driver

can easily press it.

1. Connect the microphone cable to the speak

button for voice recognition.

• When the voice recognition microphone/speak button

is mounted, the zip wire can be further split to

lengthen it.

1) Mount the microphone and the speak button in

your desired locations, and split the zip wire until

both can be connected.

2) Use vinyl tape and bind the wire so that it will not

split further.

2. Apply the double-faced tape to the back side of

the speak button for voice recognition. After

finding an appropriate mounting location, peel off

the paper backing and press in place.

Note:

Before applying the double-faced tape, the mounting

location area must be clean and free from any dirt or

grease.

3. Mount the microphone for voice recognition.

As the cable connection is

subject to vibration, etc.,

bind the connection with

vinyl tape so that it will not

come apart.

Split the wire

wire

Vinyl tape

Speak button for

voice recognition

Microphone for

voice recognition

Cable clamp

Antenna

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 118 119

Comments to this Manuals

No comments

Alpine HCE-100XM - XM Radio Data Receiver Owner's Manual Page 84

Comments to this Manuals

Related products and manuals for Car navigation systems Alpine HCE-100XM - XM Radio Data Receiver