Alpine HCE-100XM - XM Radio Data Receiver Owner's Manual Page 83

  • Download
  • Add to my manuals
  • Print
  • Page
    / 119
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 82
5
2 Prepare tools and mounting information.
3 Park the vehicle in a safe and level location.
Note:
Before working on the installation check and verify that
your vehicle lights are working correctly and your
vehicle status indicators e.g. Engine needs service, etc.
are not on. If these indicators are on, please resolve the
problem before installing the Navigation System.
1 Check accessory parts.
× 5
× 2
Screwdriver
Pencil and eraserSpanner
PliersElectrical tape
Antenna
1. Preparation
Power cables
13P RGB extension
cable (6 m)
1 Bracket 5
Flanged self-tapping
screw (M5 × 15)
4 Hex bolt (M6 × 50)3 Screw with double
washer (M4 × 8)
2 Floor base
One each for left
and right
6 Spring washer
(M6)
7 Flanged hex nut
(M6)
8 Wing nut (M6) 9 Velcro fastener " Self-tapping
screw (M3
×
12)
! Velcro tape
×
4
×
4
×
4
×
2
×
4
× 2
Battery (AAA)
Remote control holder
Remote control
Solderless connectorParking brake aux. cord
Antenna mounting plate
GPS antenna (5 m)
4 Apply the brake and remove the ignition key.
5 Mount the antenna on the roof.
Clean dust and oil at the mounting location and
mount the antenna.
Notes:
The magnet of the antenna is very strong. Proceed
cautiously to prevent any damage to the vehicle’s body.
Keep the magnet away from articles susceptible to
magnetic fields such as credit cards, watches, etc.
Do not paint the antenna. Reception sensitivity may be
decreased.
×
2
×
4
×
4
×
4
(2.5 m) (4.5 m)
Cable clamp
(for GPS antenna)
Microphone for voice
recognition (3.5 m)
Speak button for voice
recognition (7 m)
double-faced tape
(for voice recognition
Speak button )
Cable clamp
(for voice recognition
Speak button )
× 4
Multimeter
Page view 82
1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 118 119

Comments to this Manuals

No comments