Alpine LXi - NG Operations Instructions

Alpine LXi Series Gas Fireplaces 1 LXi Series POSITIVE PRESSURE GAS FIREPLACE MODEL : LXi – NG Natural Gas

Alpine LXi Series Gas Fireplaces 10 also the blower motor itself. These switches are connected in series or end to end. The other two wires comin

Alpine LXi Series Gas Fireplaces 11 size of the insert. The 360 model has three top logs while both the 270 and 310 models have two top logs. The top

Alpine LXi Series Gas Fireplaces 12 flame to impinge on both the thermocouple on the left side and the thermopile on the right side of the pilot head

Alpine LXi Series Gas Fireplaces 13 installed on this fireplace. The remote control kit comes with a hand held transmitter, and a receiver. The remote

Alpine LXi Series Gas Fireplaces 14 This appliance must be installed in accordance with local codes, if any; If not, follow the current ANSI Z223.1 W

Alpine LXi Series Gas Fireplaces 15 turning it clockwise will decrease the flame height. 12) The fan control switch will vary the speed of the fan or

Alpine LXi Series Gas Fireplaces 16 INSTALLING VALVE 1) Mount valve to valve holder 2) Place valve / valve holder back into position 3) Secure valv

Alpine LXi Series Gas Fireplaces 17 THERMOPILE / THERMOCOUPLE 1) Remove the glass door 2) Open the bottom valve chamber 3) Double check to make sure g

Alpine LXi Series Gas Fireplaces 18 Fig. 22– Hearth Clearances Clearances From Unit (See fig 20) Sides A 00” Ceiling B 00” Mantel C See Fig

Alpine LXi Series Gas Fireplaces 19 NOTE: Before troubleshooting the gas control system, be sure the external gas shut off is in the “ON” position. WA

Alpine LXi Series Gas Fireplaces 2 Because masonry chimneys may crack due to settling, SAFETY INFORMATION Safety Label ...

Alpine LXi Series Gas Fireplaces 20 Fasteners Self Tapping Screws-#8 DV-04-210 Self Tapping Screws-#10 DV-04-215 Glass Clip Screws-10

Alpine LXi Series Gas Fireplaces 21 This option shows the Air Intake Pipe connected to the Intake Collar and terminated 4' inside the chimneyThis

Alpine LXi Series Gas Fireplaces 22 FIELD INSTALLED PARTS Termination Cap (#09317)Venting Adapter (#09318)Band Clamp (#08530)3" Aluminum Ventin

Alpine LXi Series Gas Fireplaces 3 LABEL SAFETY INFORMATION

Alpine LXi Series Gas Fireplaces 4 1) The appliance installation must conform with local codes or, in the absence of local codes, with the current

Alpine LXi Series Gas Fireplaces 5 SYSTEM SPECIFICATIONS (2500 To 6500 feet altitude) Burner Inlet Orifice Sizes: LXi – 270 LXi – 310 LXi – 360 NG

Alpine LXi Series Gas Fireplaces 6 INSTALLATION REQUIREMENTS Note: Do not damage any existing flue tiles that may be to either side of the fireplace

Alpine LXi Series Gas Fireplaces 7 2) Pull the bottom of the Trim forward about 4 inches. 3) Lift the trim up about ½ inch. 4) The trim should now

Alpine LXi Series Gas Fireplaces 8 approved. Two 3” chimney liners (#09400) are used with Alpine LXi series inserts. One liner will supply the combus

Alpine LXi Series Gas Fireplaces 9 connections. If a liner is punctured or torn, it must be replaced. See PAGE 21 for Supplemental Venting Information