Alpine CVA-1006 Owner's Manual download pdf (Page 28)

26-EN

Auxiliary Device Operation (Optional)

Operating Auxiliary Devices

To operate your devices connected to the AUX

terminals on the rear panel of IVA-C801/CVA-1006,

follow the procedure described below.

WARNING

It is dangerous (and illegal in many states) for the

driver to watch the TV/Video while driving the

vehicle. The driver may be distracted from looking

ahead and an accident could occur.

Install the IVA-C801/CVA-1006 correctly so that

the driver cannot watch TV/Video unless the

vehicle is stopped and the emergency brake is

applied.

If the IVA-C801/CVA-1006 is not installed

correctly, the driver will be able to watch the TV/

Video while driving the vehicle and may be

distracted from looking ahead causing an

accident. The driver or other people could be

severely injured.

To activate your auxiliary devices:

To watch a video source, your vehicle must be

parked with the ignition key in the ACC or ON

position. To do this, follow the procedure below.

1. Push the foot brake to bring your vehicle to a

complete stop at a safe location. Engage the

parking brake.

2. Keep pushing the foot brake and release the

parking brake once then engage it again.

3. While the parking brake is being engaged the

second time, release the foot brake.

NOTE

For automatic transmission vehicles, place the transmission

lever in the Park position.

(IVA-C801) (CVA-1006)

SOURCE

Rotary encoder Rotary encoder

Now, the locking system for the AUX mode operation

has been released. Unless the ignition key is turned

to the OFF position, the AUX mode can be activated

by engaging the parking brake without performing

the above procedure (1 through 3).

Each time the ignition key is turned to the OFF

position, perform the above procedure.

NOTE

If you try to activate the auxiliary device while driving, the

display will show the warning-CAN'T OPERATE WHILE

DRIVING.

1 Press the SOURCE button.

The main menu screen appears on the display.

2 Rotate the rotary encoder and select "AUX", then

press the rotary encoder to execute the

selection.

NOTE

If the AUX mode is not displayed on the main menu,

select "AUX IN" in the Setup mode screen. Either AUX1

or AUX2 should be turned ON.

1 ... 27 28 29 ... 68

Comments to this Manuals

No comments

Alpine CVA-1006 Owner's Manual Page 28

Comments to this Manuals

Related products and manuals for Car video systems Alpine CVA-1006