Alpine IVE-W535BT Owner's Manual Page 90

  • Download
  • Add to my manuals
  • Print
  • Page
    / 100
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 89
90-EN
01GB07IVE-W535BT.fm
ALPINE IVE-W535BT 68-21057Z54-A (EN)
Installation
Caution concerning the installation location
1
Angle of installation
Install at an angle between horizontal and 30°. Note
that installing at an angle outside of this range will
result in a loss of performance and possibly
damage.
2
Mounting the Microphone.
For safe use, make sure of the following:
location is stable and firm.
driver’s view and operations are not obstructed.
microphone is located where the driver’s voice can be easily
picked up (on the sun visor, etc.).
When you speak into the microphone, you should not have
to change your driving posture. This may cause a
distraction, taking your attention away from safely driving
your vehicle. Carefully consider direction and distance while
mounting the microphone. Confirm that the driver’s voice
can be easily picked up at the selected location.
3
Remove the mounting sleeve from the main unit (see
“Removal” on page 91).
Slide the unit into the mounting sleeve and secure it.
*
1
If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
*
2
The supplied face plate may be mounted.
4
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the IVE-W535BT and
put the Rubber Cap on the hex bolt. If your vehicle
does not have the Mounting Support, reinforce the
head unit with the metal mounting strap (not
supplied). Secure the ground lead of the unit to a
clean metal spot using a screw (*1) already attached
to the vehicle’s chassis. Connect all the leads of the
IVE-W535BT according to details described in the
CONNECTION section.
For the screw marked “*2,” use an appropriate screw for the chosen
mounting location.
Caution
Do not block the unit’s fan or heat sink, thus preventing
air circulation. If blocked, heat will accumulate inside
the unit and may cause a fire.
Air ventilation hole
Rear of the Unit
Heat sink
<example>
0 -30°
Cable clamp
(Sold separately)
Microphone
Mounting Sleeve
(Included)
Dashboard
Rubber Cap
(Included)
Face Plate*
2
(Included)
This unit
Hex Bolt
(Included)
Bracket key
Pressure
Plates
*
1
Hex Nut (M5)
Screw
Bolt Stud
This unit
Chassis
Ground Lead
Metal
Mounting
Strap
*
2
*
1
01GB00IVE-W535BT.book Page 90 Sunday, August 5, 2012 6:45 PM
Page view 89
1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 99 100

Comments to this Manuals

No comments