Alpine DVA-7996 Owner's Manual download pdf (Page 9)

7-EN

Basic Operation

Initial System Start-Up

Be sure to press the RESET switch when using the unit

for the first time, after installing the CD changer, etc., or

after changing the car battery.

1 Make sure that the power of the unit is off. If the power

is on, press and hold the POWER button for at least 3

seconds to turn off the unit.

2 Press the RESET switch with a ballpoint pen, or any

other pointed object.

Turning Power On and Off

1 Press the POWER button to turn on the unit.

NOTE

The unit can be turned on by pressing any other button except

the eject

and CLK/TITLE button.

The volume level gradually increases to the previous

level you were listening to before the unit was turned

off. Press and hold the POWER button for at least 3

seconds to turn off the unit.

NOTE

The first time power is turned on, the volume will start from level

12.

Display Angle Adjustment

The movable display may be adjusted to 3 different

angles depending upon user preference.

1 Press the ANGLE button to adjust the angle of the

movable display.

NOTES

• The adjusted angle of the display is stored in memory. There

is no need to re-adjust the angle when the power is turned

back on.

• When the display is fully opened, if you turn off the ignition

key, after a while, the display will close fully. However, the

display will not fully close when the angle of the display has

been already stored in memory.

CAUTION

Keep hands (or any other object) away from the display while it

is opening or closing to avoid damage or injury. The back of the

movable display will get very warm under normal operating

conditions. This is not a malfunction. Do not touch.

Movable display

The DVA-7996 can be operated using both the buttons

on the main unit and the included remote control unit

(except for some operations). The section on audio

operations (excluding DVD and video CD operations)

mainly describes operations using the buttons on the

main unit. For instructions on performing operations

using the remote control unit, see page 43.

POWER

RESET

ANGLE

Detaching the Front Panel

1 Press and hold the POWER button for more than 3

seconds to turn off the power.

2 Press the (Release) button at upper left side until

the front panel pops out.

3 Grasp the left side of the front panel and pull it out.

NOTES

• The front panel may become hot in normal usage (especially

the connector terminals on the back of the front panel.) This is

not a malfunction.

• To protect the front panel, place it in the supplied carrying

case.

Attaching the Front Panel

1 First, insert the right side of the front panel into the

main unit. Align the groove on the front panel with the

projections on the main unit.

2 Push the left side of the front panel until it locks firmly

into the main unit.

NOTES

• Before attaching the front panel, make sure that there is no

dirt or dust on the connector terminals and no foreign object

between the front panel and the main unit.

• Attach the front panel carefully by holding the sides of the

front panel. This will help you to avoid pushing buttons by

mistake.

1 2 3 4 5 6 7 8 9 10 ... 64

Comments to this Manuals

No comments

Alpine DVA-7996 Owner's Manual Page 9

Comments to this Manuals

Related products and manuals for Car media receivers Alpine DVA-7996