Alpine INA-W910 Installation Manual download pdf (Page 6)

ALPINE PXA-H800_EN 68-13530Z66-A (B5)

4-EN

Mou

C800

Prepa

1 Ch

Com

Brac

Self-

(M4

Instal

Set

Check

it is no

Do no

an air

1 Us

•

5 Tightly install the bracket E at the designated paper

template position with the 4 self-tapping screws (M4 ×

14 mm) H.

Mount the brackets

symmetrically along

the paper template.

Self-tapping screw

(M4 × 14 mm) (×4)

Bracket (×4)

Paper template

6 Remove the paper template.

7 Place the Base unit on the bracket E and install the

device tightly with the 4 screws (M3 x 6 mm) G.

Base Unit

Screw (M3 × 6 mm)

Mounting the Microphone.

When measuring ImprintEQ or AutoTCR before implementing

RoadEQ automated measurement, the installation position is different.

Before installing the microphone, make sure to refer to “Automatic

Measurement Function” in the Owner’s Manual – PC or Commander

guide.

For safe use, make sure of the following:

location is stable and firm.

driver’s view and operations are not obstructed.

Mount the road noise measurement microphone on the sun

visor, dashboard or roof interior.

Installation on the sun visor is the most common installation

position to measure road noise while driving.

Do not install the unit or wiring in a location that interferes

with driving or an air bag.

Microphone

Cable clamp

(Sold separately)

The mounting clip can be removed from the microphone base,

as in the illustration below. If you mount the microphone using

the base without the clip, use the supplied adhesive tape as

needed.

Microphone base

Clip

Adhesive tape

•

1 2 3 4 5 6 7 8 9 10 11 ... 20 21

Comments to this Manuals

No comments

Alpine INA-W910 Installation Manual Page 6

Comments to this Manuals

Related products and manuals for Receiver Alpine INA-W910