STi Series HEAT RECIRCULATING GAS FIREPLACE MODEL : STi – NG Natural Gas STi – LP Propane INSTALLATION AND SERVIC
Alpine STi Series Gas Fireplaces 10 GAS CONNECTIONS 1) Install the final gas nipple into the fireplace insert (the nipple should only extend about 3”
Alpine STi Series Gas Fireplaces 11 5. Repeat step #4 on the left side. 6. With all pieces lined up and even, secure all screws. 7. See Figure 16 for
Alpine STi Series Gas Fireplaces 12 clockwise to the “off” position. 4) Remove glass for initial startup. 5) Wait five minutes for any gas which may
Alpine STi Series Gas Fireplaces 13 13) In the event of a power outage, your Alpine fireplace my still be used as a source of radiant heat. However,
Alpine STi Series Gas Fireplaces 14 9) Connect the main gas supply to the valve (use a 3/4” wrench) 10) Double check to make sure all connection are
Alpine STi Series Gas Fireplaces 15 INSPECTING THE PILOT / BURNER Periodic inspection of the pilot and main burner is requir
Alpine STi Series Gas Fireplaces 16 Fig. 16 - Hearth Clearances Clearances to Combustibles Unless Specified (Fig. 14) Sides A 10” Ceiling B 48”
Alpine STi Series Gas Fireplaces 17 This appliance must be installed in accordance with local codes, if any; If not, follow the current ANSI Z223.1 WA
Alpine STi Series Gas Fireplaces 18 NOTE: Before troubleshooting the gas control system, be sure the external gas shut off is in the “ON” position. WA
Alpine STi Series Gas Fireplaces 19 Logs STi 270 07631 STi 310 07632 STi 360 07632 Fasteners Self T
Alpine STi Series Gas Fireplaces 2 SAFETY INFORMATION Safety Label...3 Before Start...
Alpine STi Series Gas Fireplaces 20 EXPLODED VIEW Termination Cap (#09317)Venting Adapter (#09318)Band Clamp (#08530)3" Aluminum Venting (#09400)
Alpine STi Series Gas Fireplaces 21 LIMITED LIFETIME WARRANTY ALPINE GAS FIREPLACES (801)768-8411 782 West State Street www.alpinegasfire
Alpine STi Series Gas Fireplaces 3 SAFETY INFORMATION Listed: DIRECT VENT GAS FIREPLACE HEATER Tested to: ANSI Z21.88 1998 Report No. 476-1808-00 (Ju
Alpine STi Series Gas Fireplaces 4 1) The appliance installation must conform with local codes or, in the absence of local codes, with the current N
Alpine STi Series Gas Fireplaces 5 INSTALLATION REQUIREMENTS Because masonry chimneys may crack due to settling, chimney fires, water damage, etc. A t
Alpine STi Series Gas Fireplaces 6 Note: Take special care not to damage the gasket on the appliance adapter. Note: Improper installation of gas pipin
Alpine STi Series Gas Fireplaces 7 CHIMNEY LINERS COMBUSTION AIRDAMPERFLASHINGCOMBUSTION AIRVENT LINER
Alpine STi Series Gas Fireplaces 8 INSTALLING CHIMNEY LINERS Review page 7 to become familiar with the fireplace as a system. NOTE: Never connect thi
Alpine STi Series Gas Fireplaces 9 WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
Comments to this Manuals