Alpine CDA-7998 Owner's Manual Page 51

  • Download
  • Add to my manuals
  • Print
  • Page
    / 56
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 50
49-EN
Installation
1
Slide mounting sleeve from main unit (see Removal
Procedure below). Slide the mounting sleeve into the
dashboard.
2
When your vehicle has the Bracket, mount the long hex
bolt onto the rear panel of the CDA-7998R and put the
Rubber Cap on the hex bolt. If your vehicle does not
have the Mounting Support, reinforce the head unit
with the metal mounting strap (not supplied). Connect
all the leads of the CDA-7998R according to details
described in the CONNECTIONS section.
NOTE
For the screw , provide a proper screw to the chassis installing
location.
3 Slide the CDA-7998R into the dashboard. When the unit
is in place, make sure the locking pins are fully seated in
the down position. This can be done by pressing firmly in
on the unit while pushing the locking pin down with a
small screwdriver. This ensures that the unit is properly
locked and will not accidentally come out from the
dashboard.
Removal
1 Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see the drawing
above). As each pin is unlocked, gently pull out on the
unit to make sure it does not re-lock before unlocking
the second pin.
2 Pull the unit out, keeping it unlocked as you do so.
Lock pin
Dashboard
Rubber Cap
(Included)
Bracket
Mounting sleeve
(Included)
Hex Bolt
(Included)
CDA-7998R
<JAPANESE CAR>
Front frame
CDA-7998R
Mounting Bracket
Screws (M5 × 8)
(Included)
No Pressure Here
No Pressure Here
Metal Mounting Strap
Screw
Bolt Stud
Hex Nut (M5)
CDA-7998R
Page view 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56

Comments to this Manuals

No comments