Alpine IDA-X305 Datasheet download pdf (Page 41)

39-EN

Installation

• The main unit must be mounted within 35 degrees of the horizontal

plane, back to front.

Removal

1. Remove the detachable front panel.

2. Use a small screwdriver (or similar tool) to push the

locking pins to the “up” position (see above drawing).

As each pin is unlocked, gently pull out on the unit to

make sure it does not re-lock before unlocking the

second pin.

3. Pull the unit out, keeping it unlocked as you do so.

Caution

Do not block the unit’s heat sink, thus preventing air circulation.

If blocked, heat will accumulate inside the unit and may cause a

fire.

Caution

When you install this unit in your car, do not remove the

detachable front panel.

If the detachable front panel is removed during installation, you

might press too hard and warp the metal plate that holds it in

place.

* If the installed mounting sleeve is loose in the main unit, the pressure

plates may be bent slightly to remedy the problem.

Remove the mounting sleeve from the main unit (see

“

Removal” on page 39). Slide the mounting sleeve

into the dashboard and fix it with the metal shackles.

Heat sink

Detachable

Front Panel

Less than 35°

Pressure Plates*

Dashboard

This unit

Mounting Sleeve

(Included)

Bracket

Rubber Cap

(Included)

Hex Bolt

(Included)

When your vehicle has the Bracket, mount the long

hex bolt onto the rear panel of the iDA-X305 and put

the Rubber Cap on the hex bolt. If your vehicle does

not have the Mounting Support, reinforce the head

unit with the metal mounting strap (not supplied).

Connect all the leads of the iDA-X305 according to

details described in the CONNECTIONS section.

• For the screw *, provide a proper screw to the chassis installing

location.

Slide the iDA-X305 into the dashboard. When the

unit is in place, make sure the locking pins are fully

seated in the down position. This can be done by

pressing firmly in on the unit while pushing the

locking pin down with a small screwdriver. This

ensures that the unit is properly locked and will not

accidentally come out from the dashboard. Install

the detachable front panel.

Metal Mounting Strap

Screw

Bolt Stud

This unit

Hex Nut (M5)

Lock pin

Front Frame

Screws (M5 × 8)

(Included)

This unit

Mounting Bracket

1 2 ... 36 37 38 39 40 41 42 43 44

Comments to this Manuals

No comments

Alpine IDA-X305 Datasheet Page 41

Comments to this Manuals

Related products and manuals for Car media receivers Alpine IDA-X305